Gigafast EE100-AXP, User Manual

Page: 25 / 29

Q: During installation there is a prompt for Windows Operating System CD and
you don’t have the Windows CD, what is the solution to that?
under these
lders:
l
:\windows\options\cabs
: I have specified the location and Windows still can’t find the driver under those
cation was specified and still can’t find the driver, please go to our website and
ownload the latest driver: www.gigafast.com www.gigafast.com
A: You can manually put in these paths below. Often some system files are stored
fo
c:\windows\options\instal
c
c:\windows\system
Q
folders, what now?
A: If the lo
d
Q:
an err
A:
ins
is er our technical support for further assistance.
network
Link is for it to
etermine if there is a hard connection going through the card.
* N
co
under BIOS (Basic Input Output System). To find out how to get into the BIOS please refer to
your motherboard’s user manual.
Q: How do I change the TX rate on my EE-100axp?
The card was installed successfully and during boot up the computer prompted
or message and won’t go into Windows.
Please remove the driver disk from the drive that you have previously inserted during
tallation. If that still does not help try removing the card from the PCI slot and start again. IF
ror continues to occur please call th
Q: After I have installed the card successfully, the light in the back of the
ard does not light up. c
A: Check your CAT5/RJ45 Ethernet cable and make sure its working. The light will only lit
hen the cable is plugged into the card. The ACT stands for Activity and the w
d
Q:
What is an IRQ conflict?
A:
An IRQ error occurs when one device is sharing the same source with another device on the
motherboard. To prevent this, put the network card into another PCI slot and see if that
esolves the problem. r
ote * Most of the motherboards have a built in integrated NIC. Sometimes it might have
nflicts with a third party network card. If that is the case, please disable the on-board NIC
25