Gigabyte Z390 UD, User Manual

Page: 42 / 48

A-2: Installation in Intel RST Premium With Intel Optane System Acceleration mode
If the SATA controller has been conigured in Intel RST Premium With Intel Optane System Acceleration mode,
please follow the steps below:
1. After system restarts, go to the BIOS Setup, make sure
CSM Support under the BIOS menu is disabled.
2. Go to
Peripherals\SATA And RST Coniguration
and make sure
USE RST Legacy OROM
is disabled.
If you want to enable the Optane ™ memory installed in the M2A connector, set
PCIe Storage Dev on Port
9 to RST Controlled .
3. Enter the operating system, launch the I ntel
®
Rapid Storage Technology
utility from the Start menu, and
then enable Intel ® Optane ™ Memory on the Intel ® Optane ™ Memory tab.
4. Launch the Intel ®
Rapid Storage Technology utility from the Start menu and make sure the Intel
® Optane ™
Memory has been enabled. If you want to accelerate the system drive, you can select speciic folders, iles,
or applications to accelerate using the Intel ® Optane ™
Memory Pinning
function. (The Optane ™ memory
used must have at least 32 GB capacity.)
•
An Optane
™
memory cannot be used to accelerate an M.2 PCIe SSD.
•
Do not abruptly remove the Optane ™ memory. Doing so will cause the operating system to stop
functioning correctly.
•
If you want to change/remove the Optane
™
memory, you must disable it using the Intel
®
Rapid
Storage Technology or Intel(R) Optane Memory application irst.
•
After enabling the Optane ™ memory, the related BIOS settings will remain even after a BIOS update.
- 42 -