5 - SET-UP FOR OPERATION
0060_GB_99
- PYROCERAM AND INDUCTION HOBS
11
· 20
Validity from serial number 0550010246 02/2006
5.7.2 Operator training
• Explain and show the user how the machine works according to
the instructions, and hand him this manual.
• Remind the user that any structural alterations or any building
modification or renovation may affect the combustion air supply,
thus requiring a second operation check.
5.8 Maintenance
Attention! Before doing any repair or maintenance
work, unplug the appliance.
• Never leave the hotplates on unused!
•
Do not use the pyroceram as a support surface.
•
For the plates, use pots and pans with a flat bottom and a dia-
meter not less than 16 cm. Make sure the bottom is clean,
smooth and dry to protect the pyroceram from scratches.
•
Only use suitable pans (with a ferrite base, i.e.430 steel).
•
Do not place aluminium or plastic pots, or aluminium foil, on the
hot surfaces of the pyroceram.
5.9 Pots and pans
Induction generators only work properly with saucepans with an iron,
cast iron or chrome-plated iron base. These pans may also be enamel-
led.
The generators accept all the above type of saucepans and adapt in
real time to supply the same power.
The generator does not accept unsuitable pans.
Any other product no mentioned in this paragraph should be conside-
red automatically excluded and unsuitable for use with induction
generators.
6.1 Safety, cleaning and repair rules
• This appliance is used for the preparation of meals at industri-
al level. Usage and cleaning can be carried only by expert per-
sonnel. Maintenance and repair can be carried out only by
skilled technical personnel.
• These indications must be communicated to all those con-
cerned during internal training.
• Attention! This appliance must be constantly watched over
when being used!
• Grease and overheated oil can catch fire. Use this appliance
only under constant control. Never use water to put out
grease or oil! Cover with a lid, turn off the hot plate and
remove pot from the burner.
• Parts of the appliance and attachments exposed to food
must be cleaned with detergents and rinsed thoroughly with
potable water.
• Do not clean the appliance using water jets or steam,
whether direct or pressurized!
• If the room is being cleaned with water/steam jets or high-pres-
sure equipment, it is necessary to switch off the appliance first!
• Before starting to clean the appliance, disconnect from the
mains.
• Do not use inflammable liquid to clean the appliance.
• Repairs may be carried out only by skilled personnel.
• During repairs, the appliance must undergo voltage
omnipolar insulation (local switch, i.e. safety load cut-off
switch).
• Noise emission values of the appliance in operation are below
70dB (A). This value is compulsory according to certain national
safety standards.
WARNING
Attention!
The manufacturer declines all responsibility concern-
ing mistakes included in these instructions due to translating or
printing errors: the manufacturer also reserves the right to
change the product as he see fits, though without changing its
essential features. The manufacturer declines all responsibility for
any non-compliance with the provisions contained in this manu-
al.
6.2 Instructions for use
each plate is connected to a power adjuster which lets you choose
between the minimum temperature. For initial cooking the highest
temperatures are advised.
each plate is equipped with a temperature limit switched which is
triggered when the temperature reached may damage the glass (see
paragraph 6.5.1 "What to do in case of failure").
6 - INSTRUCTIONS FOR USE
