TM951194
5
Example for RS485 Connection (Optional)
Note:
1. For RS485 network must use USB485A converter.
2. End of wire must connect 120 Ohm terminal resistor.
3. The reader ID is up to 32. Important must have procedure before installation.
(Before connect reader, please setup the reader ID, as below figure.)
Example for Door Lock Connection (for Normal-opened type of Door Lock)
Remark:
1. DO NOT connect power supply from the 8pin connector when you have connected the power supply from
VIN at the 7pin connector to avoid damaging the unit.
2. If the lock requires power to lock (eg. EM lock), connect this point to NC
If the lock requires power to unlock (eg. Electric strike), connect this point to NO
Power Supply
DC12V / 1A
A
EL
Electric
Door Lock
note 3
see remark 2
