GIGA-BYTE TECHNOLOGY GA-H97M-HD3, User Manual

Page: 27 / 40

- 27 -
2-5 Peripherals
&
Initial Display Output
Speciies the irst initiation of the monitor display from the installed PCI graphics card, PCI Express graphics
card or the onboard graphics.
IGFX Sets the onboard graphics as the irst display.
PCIe 1 Slot Sets the graphics card on the PCIEX16 slot as the irst display. (Default)
PCI Sets the graphics card on the PCI slot as the irst display.
&
XHCI Mode
Allows you to determine the operating mode for the xHCI controller in OS.
Smart Auto This mode is available only when the BIOS supports the xHCI controller in the pre-boot
environment. This mode is similar to
Auto , but it adds the capability to route the ports
to xHCI or EHCI according to setting used in previous boots (for non-G3 boot) in the
pre-boot environment. This allows the use of USB 3.0 devices prior to OS boot. xHCI
controller enabling and rerouting should follow the steps in
Auto , when previous boot
routs ports to EHCI. Note: This is the recommended mode when BIOS has xHCI pre-
boot support. (Default)
&
Administrator Password
Allows you to conigure an administrator password. Press <Enter> on this item, type the password, and
then press <Enter>. You will be requested to conirm the password. Type the password again and press
<Enter>. You must enter the administrator password (or user password) at system startup and when entering
BIOS Setup. Differing from the user password, the administrator password allows you to make changes to
all BIOS settings.
&
User Password
Allows you to conigure a user password. Press <Enter> on this item, type the password, and then press
<Enter>. You will be requested to conirm the password. Type the password again and press <Enter>.
You must enter the administrator password (or user password) at system startup and when entering BIOS
Setup. However, the user password only allows you to make changes to certain BIOS settings but not all.
To cancel the password, press <Enter> on the password item and when requested for the password, enter
the correct one irst. When prompted for a new password, press <Enter> without entering any password.
Press <Enter> again when prompted to conirm.