Giant P400-5100 Series, Operating Instructions/ Repair And Service Manual

Page: 4 / 12

4
Consult the factory for special requirements that must be met if the
pump is to operate beyond one or more of the limits specified above.
1
NOTE:
In order to drive the pump from the side opposite the present shaft extension, simply
remove the valve casing from the crankcase and rotate the pumps 180 degrees to the
desired position. Be certain to rotate the seal case (item #20) as well, so that the weep
holes are down at the six o’clock position. Exchange the oil fill and the oil drain plugs,
also. Refer to the repair instructions as necessary for the proper assembly sequence.
HORSEPOWER RATINGS:
The rating shown are the power
requirements for the pump. Gas
engine power outputs must be
approximately twice the pump
power requirements shown above.
We recommend a 1.15 service fac-
tor be specified when selecting an
electric motor as the power source.
To compute specific pump horse-
power requirements, use the
following formula:
HP = (GPM X PSI) / 1450
SPECIAL NOTE:
The theoretical gallons per revolution
(gal/rev) is 0.00679. To find specific
outputs at various RPM, use the
formula: GPM = 0.00679 x RPM
Specifications
Model P422-5100
U.S. (Metric)
Volume ........................................................................... Up to 9.9 GPM ........................... (37.3 LPM)
Discharge Pressure ...................................................... Up to 2600 PSI .............................. (180 bar)
Power Required ............................................................. 17.7 BHP ......................................... 13.2 kW
Inlet Pressure ................................................................ -4.35 to 145 PSI .................... (-0.3 to 10 bar)
Stroke ............................................................................ 0.94” ................................................. (24mm)
Crankshaft Speed ...................................................................................................... Up to 1450 RPM
Plunger Diameter........................................................... 0.87” ................................................. (22mm)
Temperature of Pumped Fluids ..................................... Up to 160
o
F ...................................... (70
o
C)
Inlet Ports ............................................................................................................................ (2) 1” BSP
Discharge Ports ................................................................................................................ (2) 3/4” BSP
Shaft Rotation ........................................................................................ Top of pulley toward fluid end
Crankshaft Diameter ...................................................... 1.102” ............................................... (28mm)
Key Width ...................................................................... 0.315” ................................................. (8mm)
Shaft Mounting .................................................................................................................. Either side
1
Weight ........................................................................... 38.3 lbs ........................................... (17.4 kg)
CrankcaseCapacity ....................................................... 30.4 fl.oz. ..................................... (0.9 liters)
Volumetric Efficiency @ 1450 ..................................................................................................... (0.95)
Mechanical Efficiency @ 1450 ................................................................................................... (0.83)
NPSHR .......................................................................... 22.3 ft. of head ............................... 6.8 mWs
P422-5100 Horsepower Requirements
RPM GPM 1000 PSI 1500 PSI 2600 PSI
900 6.1 4.2 6.3 10.9
1050 7.1 4.9 7.3 12.7
1160 7.9 5.4 8.2 14.2
1300 8.8 6.1 9.1 15.8
1450 9.8 6.8 10.1 17.6