EnergyPak Plus
INSTALLATION & USER MANUAL
4 / 8
Double check if the mounting plate is firmly secured on the frame. Make sure no bottle
cage bolts or other items are sticking out above the surface of the baseplate.
STEP 6
Put in a mounting plate bolt ( IV. ) from the top of the baseplate. Loosely screw it into the
nut a few turns. Repeat with the second nut and bolt on the other end. Tighten both bolts to
4 N•m.
Make sure the nuts do not rotate while tightening. Block the rotation with a 10mm wrench if
necessary.
STEP 5
Put a mounting plate nut ( V. ) in the top hole from the inside of the frame. Hold it in place
with a finger. Place the base plate ( III. ) onto the nut coming out through the frame.
STEP 4
7. MOUNTING KIT INSTALLATION
It is strongly advised to have the EnergyPak Mounting kit installed at your Giant dealer by a skilled mechanic. Use only the
original parts and hardware supplied in the mounting kit.
Remove the rubber plugs from the EnergyPak Plus mounting holes in the downtube.
Push the plug from the inside of the downtube and pull out from the top.
STEP 3
Remove any installed bottle cage, bolts or other accessory from the bottle cage mounts.
STEP 2
Remove the EnergyPak Smart from the bike.
STEP 1
