Giant-Vac Bobcat Series, Operator'S Manual, Page: 8 / 36

Set bottom of support assembly onto pins in
bottom of bumper mount.
Holding support assembly upright, align holes
in support assembly with corresponding holes
in bumper mount and reinforcement brace.
Slide 5/8 x 17” locking pin through holes in
bumper mount, securing with 2-1/2” oal bridge
pin. Slide 3/8 x 18” locking pin through holes
in top of reinforcement brace, securing with 1-
7/8” oal bridge pin.
Now tighten all brace hardware securely.
3
unit assembly
Bagger Installation - 2 Bag Units
(Cont.)
Install the reinforcement brace assembly onto
the unit, utilizing the square holes in the
engine base. Secure with four 5/16-18 x 3/4”
carriage bolts (inserted up from under the
engine base) and serrated flange nuts. Note:
Do not tighten brace hardware until support
assembly in following steps is installed.
Attach Cross Assembly (with attached hood
assembly) to Cover Support Assembly with
four 3/8-16 x 3/4 hex bolts and four 3/8-16 ser-
rated flange nuts. Tighten securely.
Attach Cover Latch Arm to Cover Support
Assembly with two 5/16-18 x 3/4 hex bolts and
5/16-18 serrated flange nuts. Tighten secure-
ly.
8
Bolts
Cross
Assembly
Cover Latch
Arm
GVTP ZVBB-R0203.1