Giant-Vac Bobcat Series, Operator'S Manual, Page: 7 / 36

Weight Bar Kit Installation - All Models
(61” shown)
!! Warning: Weight kit must be installed
prior to installing bagger unit. Failure to do
so may result in longitudal tipping of unit.
Lay weight mount channel across front end of
unit as shown. Secure to unit with two clamp
plates, one under each caster arm, each held
on with two 3/8-16 x 3-1/4” hex bolts and two
reverse lock nuts. Tighten securely.
Secure weight bars to weight mount channel
with three 1/2-13 x 3-1/4” hex bolts and three
serrated flange nuts. Tighten securely.
!! Warning: Always install all supplied
weight bars onto weight mount channel.
Failure to do so may result in longitudal tip-
ping of unit.
Bagger Installation - 2 Bag Units
Assemble bumper mount plate onto rear
bumper bar of mower. Use two bar clamps on
top portion of plate, fastening from in front of
bumper bar, with four 3/8-16 x 1-1/4” hex bolts
and serrated flange nuts. Fasten bottom with
one bumper spacer and same hardware as
above. Tighten all hardware securely.
Assemble the upper reinforcement brace as
shown, using two 3/8-16 x 1-1/4” hex bolts, fit-
ted with two 3/8” flat washers, and securing
with two 3/8-16 serrated flange nuts. Do not
tighten hardware.
unit assembly
3
7
Top View
Rear View
GVTP ZVBB-R0203.1