TO SHUT ENGINE DOWN :
•
Allow engine to idle for 2-3 minutes before shutting down.
•
Turn ignition key to ‘off’ position.
•
If engine is not to be started for a prolonged period, turn red fuel valve to closed
position.
3. OPERATING THE UNIT:
ADJUSTING THE NOSE CONE:
Adjustable rubber flaps along the entire perimeter of the large 48” nose cone * make
your Model 1695 Trail-Vac suitable for virtually any surface. To adjust the flaps, simply
loosen the bolts securing the flap bolt plates to the nose cone body, and slide the flap
assembly up or down to suit the particular application. Generally, the harder and
smoother the surface (such as parking lots), the closer to the surface the flaps should be
adjusted; the softer and rougher the surface (such as grassy fields), the higher the flaps
should be set. Experience will be your best guide. As a rule of thumb, however, the
rearmost flap should always make contact with whatever surface the Trail-Vac is
operating on.
* Model 1695 MO E has a rotary mower attachment in place of the nose cone. This
option consists of an intake flange that attaches directly to the power unit, a six-foot
length of 6” diameter hose, two 6” hose clamps, and a special universal chute that
attaches to the discharge portion of a mower deck, in place of the deflector. The chute
is adjustable and will fit most model tractors.
UTILIZING THE OPTIONAL NOSE CONE MOUNT HOSE KIT:
In addition, the nose cone is designed to accept an optional intake hose kit, making the
Trail-Vac an incredibly versatile piece of debris removal equipment. This option allows
for easy access into areas that the Trail-Vac is unable to maneuver into. For further
information regarding this and other optional accesories, please refer to the options
section further along in this manual.
To attach the hose kit, first remove the auxiliary intake cover (Parts List Ref. # 36, Sheet
1) from the upper portion of the nose cone body. Then, using the same mounting
hardware, fasten the intake flange to the auxiliary intake, tightening the mounting bolts
securely. Next, slide one hose clamp onto one end of the intake hose, approximately 1-
2” from the end. Slide this end of the hose onto the intake flange, and tighten the clamp
securely. Slide the other hose clamp onto the loose end of the hose in like manner, then
slide the end of the hose onto the intake nozzle. Tighten clamp securely.
To utilize the intake hose kit, remove the nut, lockwasher, and inner door lever clip from
the left side of the nose cone body (Ref #’s 10, 11, 12; refer to Parts List Sheet 1), and
flip the door lever up to a vertical position. This will close the bottom portion of the nose
cone, deflecting all suction to the auxiliary intake. (Helpful hint: If intending to utilize the
