UNIT OPERATION
1. CONNECTING UNIT TO TOWING VEHICLE:
Connecting the Model 1695 Trail-Vac to a towing vehicle is fast and easy – simply align
the hole in the forward section of the Trail-Vac’s A-frame hitch with the rear hitch mount
of the towing vehicle, and secure with a heavy-duty hitch pin (not supplied).
2. STARTING THE ENGINE
NOTE: If you experience problems with your engine that cannot be satisfactorily resolved by
following the instructions contained within the engine manual, contact your local engine dealer, or
call the toll-free service number listed in the repair section of the engine manual. All engine
service, warranty or otherwise, is required to be performed by a manufacturer-authorized service
center. Giant-Vac Mfg., Inc. is neither authorized nor responsible for any type of warranty engine
service, nor is it equipped to perform any such service.
BEFORE STARTING ENGINE:
•
Be sure to read your engine manual carefully and thoroughly before attempting to
start the engine.
•
Be sure that the unit is
completely
assembled, and all safety guards and
components are in place.
•
Be sure to check engine’s
oil
and
gasoline*
. (See engine manual for recommended
oil and gasoline specifications.)
Never
check the engine while it is running or while
you are smoking. Check only when engine is cold.
*
All machines are shipped without oil or gasoline unless otherwise noted.
•
Be sure that red fuel valve on engine is set to open position.
TO START ENGINE :
•
Set throttle control up to “full” position. If engine is cold, set choke by pulling out
choke handle.
•
Turn ignition key and hold until engine starts. (If engine fails to start within a
reasonable amount of time, discontinue and check engine manual for further
instructions.)
•
After engine starts, release ignition key, move throttle control down to approximately
half, and turn off choke as required.
2
