Copyright © All Rights Reserved. P-MU-ML301-SW Published: 2020.04.29
3-2
Copyright © All Rights Reserved. P-MU-ML301-SW Published: 2020.04.29
3-3
Wiring Diagram
For the 12~24VDC/AC operation only
12~24VDC/AC Power supply
“Fail-Safe”
(Power to Lock)
Red
Red
Varistor
(Power input is polarity free)
Yellow
Green
Blue
Access Control Device
N.C. contact
Red
Red
Varistor
12~24VDC/AC Power supply
(Power input is polarity free)
“Fail-Secure”
(Power to Open)
Yellow
Green
Blue
Access Control Device
N.O. contact
NOTE:
The varistor (or diode) must be connected across the terminals as shown above. This protects the electromechanical
lock from spikes and surges.
ø5.0
ø5.0
ø5.0
30
19.5
30
86.5
318
275
25
30
19.5
ø5.0
ø18.0
ø11.0
150
206
Alignment CL
Cut on dotted line
Alignment CL
Alignment CL
Door leaf edge
Door leaf edge
Template
Unit:mm
Butt Splice (IDC) Connector
Using crimper or pliers and pressing the header of
connector down to even position.
62mm cylinder for max
•
42mm door leaf
72mm cylinder for max
•
52mm door leaf
ø5.0
ø5.0
25
28
150
28
124
250
30
30
5
6
7
8
30
ø5.0
ø5.0
1
2
3
4
Unit:mm
Installation Instructions
Do
or l
ea
f
Doo
r F
ram
e
Door Loop
(Optional)
(Cylin
der
not in
clude
d)
Align the center line (CL) of the
Alignment CL
Fram
e
Do
or L
eaf
Do
or L
eaf
Cut out mortise holes for the lock
Tighten the fixing lugs with
screws.
Drill and cut the hole for the lock
Connect power cable to the lock
Attach the cover plates for the
Install the cylinder
Fix the strike plate.
The door loop protects the wiring
from damage at the door hinge.
Attention! Please ensure that the
direction of the template is correct
Doo
r Fra
me
lock body template with the CL of
the door leaf. Ensure the CL of the
strike plate template matches the lock
body CL as closely as possible.
body and strike plate and drill holes
according to the templates.
cylinders as shown in the template.
and test before screwing to the
door leaf.
cylinder lock
Optional Lock Bolt Sensor (LBS) Status Output:
With LBS output:ML-300-SW
Without LBS output:ML-301-SW
