3.
F. USING THE POWER INVERTER
1. Check the output voltage and capacity of the battery. The battery (s) should match
the voltage of the inverter and have enough capacity for the load.
2. Insert the cigarette plug into the car cigarette socket and ensure well connected.
3. Press the power switch button on your inverter and a green LED will light up
indicating that the inverter is on.
4. Before plugging anything into your inverter, make sure the appliance you are trying
to power is shut OFF, then plug it into the AC outlet of your inverter and power on
your appliance.
5. Once finished using the inverter, turn off your electrical appliance and the inverter.
The indicator lights should be off.
AC outlet
USB ports
LED display (battery input
voltage, fault codes display)
Power indicator
Fault indicator
4.
Warning:
The car cigarette outlet usually has current limit requirements. It is
suggested that the continuous load power should not exceed 100W when the
original cigarette holder is supplied, otherwise the car built-in fuse may be burned.
If more power requested, a special cigarette outlet should be supplied to connect
directly from battery.
G. USING THE USB
The inverter provides dual USB ports and stable 5V DC to the external device, the
total maximum current is 4.8A, and the maximum output current of a single USB
port is 2.4A, which can directly supply or charge a portable device with a USB
interface.
USB ports built-in automatic charging identification IC, support various charging
protocols.
H. BATTERY
Battery operating time depends on battery capacity and load. The formula for
operating time is: battery capacity divided by the value of the load divided by
battery voltage times 1.10%. For example, using the numbers from above, the
battery specification is 12V, 100Ah capacity and the load is 180W. Take battery
capacity 100Ah *12/ 180
≈
6.6 hours of run time if you fully deplete the battery. This
is NOT recommended. Deep cycle batteries last longer when they are only
depleted to 50% of capacity.
I. SOFT START TECHNOLOGY
The soft start technology built into this inverter protects the unit from delivering
too much AC power at once by gradually increasing the AC voltage pushed out. To
make sure that you are utilizing this feature, turn on the appliance being used
before turning on the inverter. This is especially necessary for equipment that has
an inductive load or electrical motor.
J. OUTPUT VOLTAGE & WAVEFORM
The electrical waveform output of this inverter is Modified sine wave, which has the
same quality as utility and/or domestic power. This type of waveform is suitable for
most electrical devices, appliances and tools. This pure sine wave unit provides
more capabilities than modified sine wave inverters because it is a cleaner form of
power. The pure sine wave also effectively reduces the noise produced while using
appliances.
K. PROTECTIONS IN THE INVERTER
1. Input under-voltage alarm(LO): When the input DC voltage is lower than 9.8V, LED
display will indicate “LO”, the buzzer will whistle intermittently to remind that the
inverter will go into the under voltage protection.
2. Over voltage protection(HI): The inverter will automatically shut down when the
input DC voltage is higher than 16V. LED display will indicate “HI”. The buzzer will
whistle continuously and the green light is off, red light is on. Please turn off the
inverter and adjust the input voltage to the admissible range.
E. Parts list
Cigarette
Lighter
Switch
Cooling fan
