20
www.giadatech.com
(3)If HDMI and CRT display devices were connected at the same time, the
default display mode is the Intel (R) Dual Display clone mode, the maximum
resolution can be up to 1366x768 (can also set other higher resolution, but the
HDMI display will be missed)..
If the problem can't solved even after the above measures are taken, you may
contact our customer service center or log in the official forum of Giada.
Please prepare the materials listed below before you contact so as to receive
prompt service from us.
• rue product name and model;
Product code and its serial number;
Date of purchase;
Brief introduction of the problem on your PC;
Information concerning the software and other external hardware.
•
•
•
•
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This device and its antenna must not be co-located or
operating in conjunction with any other antenna or transmitter.
“To comply with FCC RF exposure compliance requirements. The antennas used
for this transmitter must be installed to provide a separation distance of at least 20
cm from all persons and must not be co-located or operating in conjunction with
any other antenna or transmitter.”