This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
■
This device may not cause harmful interference
■
This device must accept any interference received, including interference that may cause undesired opera-
tion.
WARNING G
Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
■
Reorient or relocate the receiving antenna
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
■
Consult the dealer or an experienced technician for help.
PREMIUM WIRELESS KEYPAD OVERVIEW
PROGRAMMING
All GHOST CONTROLS
®
Premium Keypads must be programmed before they will operate the Gate Opener
System so that the safety and security of your system is maintained.
WIRELESS KEYPAD
INSTRUCTIONS
PROGRAMMING
Default Factory Master Pin=
1234
The factory keypad pin will allow the keypad to be programmed but it will not actually transmit a signal to the
gate opener system controller until it has learned the unique transmitting code from a programmed and working
transmitter.
NOTE
This keypad will remain in programming mode for up to one minute between key presses to allow you
adequate time to go through each step. If you happen to incorrectly press a key sequence (such as SEND,
SEND) then the keypad will immediately drop out of programming mode and you will have to start back at
Step 1 that programming sequence.
A remote transmitter that currently operates your gate opener system is required for you to be able to teach the
GhostCode to the keypad. Proper positioning of the transmitter onto the keypad is critical for this process to
work. Please see diagram below.
Learning Keypad From Working Remote
Step Button(s) Sequence to Press
LED/Alarm After
Pressing
Description
1
Press and Release
This tells the keypad that you are
going into programming mode.
2
Enter
Master Pin
Completing this step actually
allows you into programming mode.
Without the correct Master Pin,
then you will not be able to proceed
further.
3
Press and Release
This tells the keypad that you are
going to do program a special feature
into the keypad.
4
Enter 07
Code 07 tells the keypad that
you want it to learn the correct
GhostCode from a working remote.
