Ghost Controls DEP2, Installation And Owner'S Manual, Page: 37 / 70

37
P U L L - T O - O P E N
© G h o s t C o n t r o l s 2 0 1 9
F. Align the innermost hole of the estate and front mount brackets and insert (1) M8 x 65mm flat washer,
and (1) M8 nylon locknut through both holes and tighten to secure the bracket to the gate.
YOUR FRONT
MOUNT AND ESTATE BRACKET SHOULD NOW BE ATTACHED AND SECURED TO THE GATE.
G. Align and attach arm of operator to the secured front mount bracket, as shown below. Make sure all parts
installed during installation are tightened down.
STEP 15.
REPEAT STEPS 1 – 14 FOR INSTALLING SECOND GATE OPERATOR. (SKIP STEPS 7 & 8)
NOTE
Refer to image on page 14 for second operator. You will need to dig a trench and use pvc conduit to put second opera-
tor power cables thru to connect to the control box on the opposite side of the driveway.
STEP 16. Install the Positive Stop Plate.
Use the supplied Positive Stop Plate and U-bolts to install the Positive Stop Plate on the INSIDE OF THE FIRST
OPERATOR GATE as shown in the image below.
STEP 17. Proceed to Programming the Closed Limit Switch Step 18.
B. Install the front mount gate bracket and estate bracket on the gate by aligning the outermost hole of both
brackets and inserting (1) M8 x 65mm flat washer, and (1) M8 nylon locknut through both the estate and
front mount bracket, as show below. Tighten to secure the brackets to the gate.
MAKE SURE GATE IS STILL
IN OPEN POSITION (arm must be fully retracted).
Estate Bracket install
on backside of gate
Front Mount Bracket
C. Disconnect operator from gate bracket and swing away from the gate.
D. Assemble clevis pin, front spacer and hair pin to operator to prevent loss.
E. Now you can mark and drill the inner most hole on the front mount bracket, shown below.
Mark and drill
center location of
innermost hole
CL
Remove the clevis pin,
hair pin, and front spacer.
Temporarily assemble cotter pin,
hair pin, and front spacer into
front mount