Bedienungsanleitung
As of 04/20/2010
Seite 13/16
4.2
Open the housing
Before you can insert a module, it is necessary to open the housing. The steps to do this are described in
the ProfiLux manual.
The opened device looks as follows:
In the top left-hand you can see the sockets in which the modules have to be inserted. Next to it on the
right you can see the connectors of the built-in sensor inputs. In front of the Expansion Box there are the 5
module cover plates and the more narrow back plate for the – seen from the back – the right side.
4.3
Insert the module
The new module can be inserted into any slot – except slot Modul 4 (slot nearest to the housing). This slot
only supports analog measurement cards at the moment.
When you insert it, pay attention that all contact pins of the module disappear in a socket of the slot. No
contacts may "remain"! The insertion has to be possible easily and without having to use any force!
4.4
Close the housing
Now the housing can be closed again.
First attach the upper housing part again carefully in the right direction (look at interior of cover). Check
here that front panel and rear plate move properly into the right slots, if necessary correct their position
slightly. Also here is important: Do not use force!
Afterwards attach again the 8 covering caps.
