73
19. Initialization of the software
If you notice when recalling the memory positions you have stored that these bed
positions are no longer reached, the software of the MLW must be re-initialized.
To be able to reach the bed positions you have stored correctly again, the following
steps must be carried out:
PLEASE PROCEED AS FOLLOWS
:
1.
All
drives
must be completely
retracted
, this means:
a.
The actuator for height adjustment must be moved to the lowest position
(
button
A1
of the hand control / see below, fig. 15).
b.
The actuator for the inclination (seat area / thigh area) must be level with the
legrest (calf area), i.e. adjusted horizontally.
A
TTENTION
!
Please keep
button
C1
of the hand control (see below, fig. 15) pressed
until the actuator
switches off
!
c.
The actuator of the legrest must also be retracted, i.e. keep
button D1
of the
hand control (see below, fig. 15) pressed
until the actuator also switches off
audibly
!
❖
The initialization is complete when the described positions are reached.
FIG
.
15
This adjustment (initialization) must be done manually, i.e. each drive must be
moved individually. Do not use any of the memory buttons for this
Summary of Contents for MLW F1
Page 86: ...85...