5
not equipped.
(use 2.5mm
2
cuprum wire to contact with the ground bolt)
2. Don’t start to heat when there is no oil in frypot or the oil lever lower than element, otherwise the
elements will be burn. Please don’t wash the heating element by cool water until they are cooling, or it
will explode
3. Latch the lid before heating. Don’t operate the securing hook and draining the oil. Before you open
the fryer lid, to make sure the there is no pressure in the frypot, that means the pressure gauge shows “0”.
After 30 second, you can open the fryer lid to avoid explosion for the pressure.
4. In order to keep the good sealing between fryer pot and fryer lid, do not use handle or some other hard
tools to strike the fryer lid and mouth of fryer.
5. The rubber seal of the fryer lid can not be dismantled of yourself. For it may effect the sealing. While
it is not working, you should close the fryer lid, but not too tight to avoid the aging of the seals.
6. You should cut off the power if the machine is not working in order to avoid explosion for the wrong
operation.
V. Maintenance and Upkeep of the Machine
1.
Clean the overflow valve twice weekly, screw the screw lid, and clean the gravity block, making it
jump freely and open and close flexibly. Check the general electricity and screws of power line, and
joints monthly. If any loose, fasten them to make them contact well and control sensitively.
2.
Clean the smear away from the electro thermal pipe in the boiler and cabinet after daily work is over
to keep clean and sanitary and enhance the use life span of the machine.
3.
After a relatively long time use, the rubber gasket shall be replaced in time if it is found aging and
ineffective. Loosen the glue bar fastening screws of four sides on the cover, take out the glue bar
from the groove slowly, put new sealing rings into the groove, and
fasten the screws.
4.
The machine is equipped with overheating protector.
If the temperature controller is out of
work and the oil temperature is up to 250
℃
, temperature limiter can cut off the heating power to
make sure of the safe. Operator should check the reason for overheat and try to get rid of it. If
needed, you should press the reset key in the “temperature limiter” to restart the machine.
