Gfp 563TH-4
December 2019
15
10G. Attach lower supply shaft assembly
1.
Bolt the bottom supply shaft assembly to the stand with 6 bolts by sliding the shaft through
the hole on the left side of the left stand
2.
Bolt the cover to supply shaft assembly
3.
Bolt machine alignment brackets to the outside of machine stand
11. Additional Installation items
1.
Remove the shipping blocks and wire ties from the ends of the rollers before
attempting to raise the top roller!
2.
Check drive chains for tightness
3.
Check all drive set screws for tightness
4.
Check all electrical connections and input power and test for proper operation
12. Loading Film
1.
Rotate the locking outer sleeve in the direction of the arrow
to the open position, aligned
with the inner sleeve
2.
Swing the supply shaft out to load position and slide the film roll onto the shaft
Note: If using Liner-in film, the web should come off the bottom of the roll, for Liner-out
film, the web should come off the top of the roll (see treading diagram in section #12)
3.
Swing shaft back into position and rotate locking outer sleeve to the closed position
4.
Align film roll with a number on the supply shaft, positioning the roll in the middle of the
supply shaft
Cover
Bottom supply shaft assembly
Machine alignment brackets
Tension
adjustment
knob
Slide this end of the shaft
through the bracket hole of the
left stand
Bracket hole of left stand
