Gfp 563TH-3
January 2019
16
Need to edit this image
13. Operation
1.
Plug power cord into a proper receptacle
•
Connect the attachment plug provided with the laminator to a suitably grounded
outlet only. This machine must have reliable earth wire to ensure the safety of the
machine during operations
•
Contact an electrician should the attachment plug provided with the laminator not match
the receptacles at your location
•
Ensure that the voltages of the power supply you are using match the rated working
voltages before operations. Do not use incorrect power supply
•
Do not use damaged wires or sockets. If abnormal conditions occur, switch off the power
supply first.
2.
Turn power to “ON” with the rear power switch
3.
Cold laminating:
When doing cold laminating, turn the switch to ‘Cold’
4.
Hot Laminating:
Turn switch to “Hot” and set the needed temperature
5.
When the Green Ready indicator light is on the
roller is
up to temperature
NOTE: The temperature should meet the material to be laminated. If too high,
the quality will be affected
6.
The indicted temperature shows the surface temperature of the rollers. The temperature
switch points to the set position. Actual temperature is shown on the LCD readout.
The LCD does not work
when
the machine is in the “Cold” operating condition.
14. Nip Roller Pressure Adjustment
1.
When the pressure-adjusting hand-wheel is turned clockwise, the top rubber
roller comes down and the pressure will increase
2.
With a counter-clock turn, the top rubber roller goes up and the pressure will decrease.
3.
Bring the nip roller down to just touch the film, then increase 1/8 turn.
1. Bottom supply roll
2. Front working table
3. Top heat roller
4. Linkage shaft for roller pressure-adjustment
5. Liner rewind tube
6. Paper liner
7. PSA film roll
8. Film supply web
9. Bottom nip roller
10. Bottom supply web
