page 6 of 12
‡ SIGNET
2550 InsertionMagmeter
m/s
Meters per second
To change the engineering unit selection, first enter the access
code (section 5.2.1) then press the down arrow until the display
shows:
1.
2.
3.
Step:
Press: To display:
Example illustrates changing
engineering units from
gallons per minute to
liters per minute.
ENTER key selects new
setting and returns display to
main menu.
Arrow
keys advance main menu function;
Run/Edit
key returns
to normal operation.
5.3.1
Unit
Six engineering unit options are available in the unit menu.
Select one for your flow rate display.
ft/s
Feet per second
l/s
Liters per second
l/min
Liters per minute
GPM
U.S. Gallons per minute
m
3
/h
Cubic meters per hour
The factory default setting
for Units is GPM.
ENTER
ENTER
UP arrow key changes
setting.
5.3.2
Interior diameter
You must enter the precise interior diameter of your pipe as measured during the installation process. Entry is made in inches when the
dimension entered is less than 40, and automatically switches to millimeters when the dimension entered is greater than 40.
To change the id selection, enter the access code (section 5.2.1) then press the down arrow until the display shows:
3.
2.
1.
4.
7.
6.
5.
8.
9.
10.
11.
12.
13.
The following example illustrates setting id to 10.40 in.
The decimal point location is selected after the last flashing
digit is set.
Down arrow key changes flashing digit.
The factory default setting for id is 2.067 in.
ENTER key stores new setting and advances flashing digit.
Down arrow key changes flashing digit.
Up arrow key changes flashing digit.
ENTER key stores final setting and returns to main menu.
Down arrow key moves decimal to right.
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
Step:
Press: To display:
Arrow
keys advance main menu function;
Run/Edit
key returns to normal operation.
