Powerdrive PL-HT KIT
8
Pre-installation
5
Pre-installation
The up-to-date drive drawing is applicable for the pre-installation work to be carried out. All components must
be identified and installed in accordance with the drive drawing.
5.1 Cutting the track to size
X
Check profiles for damage.
X
Cut the track (Pos. 8 in the assembly group list, Chapter 4.5) to the required length (see processing drawings,
Chapter 4.1).
X
Check whether additional bore holes are necessary (see production drawing for track made to measure,
Chapter 4.1).
X
Clean the track after processing.
5.2 Preparing the track
X
Push sliding blocks (4) and earth connectors (3) into the mounting groove in accordance with the drive diagram.
X
Screw the device flat plug (2) to the earth connector (3) using the slotted pan head screw M4 × 6 (1) (torqu
e
3.5 Nm).
