ISM Boxer
Mounting and securing
6.6 Adjust trigger and lock
X
Ensure that the wire cable is not pinched.
When adjusted correctly, the disc and the notch must be aligned.
X
Check that the release slide is still engaged. The gap between retaining disk and the mark should be 1–5 mm.
(
1.
) (see figure
A
).
X
Check that the release slide is still engaged. The gap between retaining disk and the mark should be 1–5 mm
(
2.
) (see figure
B
).
Fig.: 6.6.1
6.7
Positioning the function saveguard of the integrated closing sequence control
Fig.: 6.7.1
X
Close the fixed leaf (
1.
).
X
Connect the sliding lever with the sliding pad of the moving leaf. (
2.
) (tightening torque: 5 Nm).
X
Pull out the driver (
3.
).
X
Release the screws of the tamper-proofing device, max. 1/2 turn (
4.
).
X
Pull out the stop bar (
5.
).
à
Distance edge of lock and stop bar approx. 30 mm.
X
Open the closing time valve „1“ at the moving leaf (
6.
).
X
Close the moving leaf (
7.
).
The stop bar for the tamper-proofing device has been positioned.
X
Open the moving leaf (
8.
).
X
Tighten the screws of the tamper-proofing device (
9.
).
CAUTION
Stop bar must not be pass under the driver.
GB 7
Summary of Contents for ISM Boxer
Page 23: ...ISM Boxer Notes Notizen...
