49. Flip the black switch cover over switch.
TIP:
This protects switch and prevents
accidental heating mode.
50. Twist yellow hose connector clockwise to
the unlocked position.
51. Detach hose by sliding down the yellow
sides of hose connector.
52. Unplug Geyser and power cord.
53. Follow maintenance and care steps in
recommendations (page 14).
What To Do When “PUMP
OFF TOO HOT” Light Is On?
54. If “PUMP OFF TOO HOT” is on, then DO NOT
test water temperature with your hands.
55. Carefully dump some hot water out and
away from the power cord.
56. Add cold water until water temperature is
below 87°F and “PUMP OFF TOO HOT” light
is off.
Note:
It may take over 30 seconds after
adding cold water for the thermostat sensor
to enable pump operation.
11