USER INSTRUCTIONS
55
P15 - Sending the HOLIDAY command to the slave
devices
When the P15 code appears on the screen, it is possible
to use the
keys to enable (ON) or disable (OFF)
the extension of the HOLIDAY command to the slave
devices to the timer-thermostat. Press the
key
within 30 seconds to confirm the value set.
The parameter setting procedure has now been completed.
Press the
key to return to normal operating mode.
To customise the preset daily programme, or modify the settings, press the
key
twice.
The message “PROG” is displayed on the screen, while
the bar of the first day of the week starts to blink.
Select the required day using the
keys.
Press the
key within 30 seconds to confirm the
selection.
After confirmation of the day, the current profile, relative
to the day selected, is displayed on the screen. The time
will start to blink.
Follow the steps below to customise the settings:
1 - select the starting time for the change in temperature
2 - set the new temperature set point
3 - completing the customisation process
1 - select the starting time for the change in
temperature
Use the
keys to modify the time until the time for
modifying the proposed profile is reached: the column
relative to the time selected will blink during the
increment of the time profile. The time is
decremented/incremented in steps of 15 minutes each
time the
keys are pressed, so it is possible to
define up to 4 programming periods each hour.
Customising the daily programme
E
N
G
L
I
S
H
