instead of a power adaptor
Alternatively you may use a transformer to supply the
video door entry system with electricity (GEV order
no. 8834402).
Performance Settings
While the monitor is switched on you can adjust the
brightness, contrast and color of the monitor in which
you press the „settings/confirmation“ button. (6). If
you press this button (see above) the menu appears
on the monitor. By pressing the „up“/„down“ buttons
(7, 8) you can scroll through the menu. Select the
submenu and confirm by pressing the setting button
(6). Once you are in the submenu scroll through it by
using the „up/down“ (7, 8) buttons, too, to choose the
appropriate settings for you. Confirm this again by
pressing the „confirm button“ (6).
Operating Instructions
Important: the touch keys must be handled by slightly
touching with the fingers.
1. Activation of units
When the call button on the outside camera unit is
pressed, the indoor unit chime rings and the visitor’s
picture will appear on the indoor monitor. After the
visitor is visually identified, and you wish to talk with
the visitor, touch the
button. The unit will remain
activated for approximately 60 seconds before it
automatically shuts off. To re-activate for continued
conversation, touch the
button and then touch the
button.
Should you not react on an incoming signal, the
monitor will go in stand-by after approx. 30 seconds
2. Activation of outside unit from monitor unit.
a) Touch the
button of the indoor unit at any time
and the outdoor camera will be activated and show
the outside view.
b) If you has installed two cameras, touch this button
to change from camera one to another.
3. Activation of “Intercom”
button (optional)
An intercom calling can be started by any indoor
monitor.
When the intercom
button on one indoor monitor
is touched, this will ring all monitors in a system,you
can talk with the one calling monitor by touching the
intercom button on the second monitor, touch
for
shutting off. There is approximately 60 seconds of
time before the unit automatically shuts off.
4. Door opener
button
If an electrical lock or door strike is added to the
installation, connect it to the terminals at the back of
the roadside panel.
If you want to open the door to let the caller in, just
touch the
button on the indoor monitor.
This function can only be used when the screen
is switched on. After usage the monitor switches
back to operating mode. It is normal that the image
switches off one moment following the control of the
door open.
Important: it is essential that the electric latch or lock
8
installed has a mechanical memory. We recommend
to use our GEV door openers order no. 007680 (11
cm) or order no. 007697 (25 mm) with appropiate
transformator Order No. 007505B.
5. Activation of
button (optional)
If you have connected an additional gate or a second
door: If you want to open the gate to let the caller
in, just touch the
button on the indoor monitor.
This function can only be used when the screen is
switched on. It is normal that the image switches off
one moment following the control of the gate opener.
6. Changing the melody
At standby mode, touch the
button, you can hear
the melody. Then touch
to choose target melody.
There are 4 melodies available. To confirm melody
you have chosen, touch
button.
Recycling instructions
This device may not be disposed of with unsorted
household waste. Owners of old devices are
required by law to dispose of this device correctly.
Contact your town council for further information.
MA_1fam_Video_88344_print.indd 8
06.06.14 11:09
