GEV 001251, Manual

Page: 5 / 35

Range test
Set the TIME controller to minimum, the LUX
controller to „Sun“ and the METER controller to
maximum (Fig. E) . If the motion detector is
connected to a separate switch, switch it on. A
self-test, lasting 60 seconds, will now begin. The
sensor LED and connected system (e.g. a light)
will remain on throughout the test. When the
system goes out, the range test will begin:
whenever movement is detected, the system will
switch on for approx. 6 seconds, regardless of the
ambient brightness. Perform this test to establish the
fi eld of detection. Set the
METER controller to the re-
levant setting. Once the device has been successfully
set, you can programme additional settings.
Additional settings (Fig. E)
LUX
twilight switch approx. 5 - 1000 Lux. When
you turn the LUX controller (the lowest
setting is „Moon“), the sensor LED will
light up if movement is detected and if the
ambient brightness is reached or exceeded.
This enables you to defi ne the current light
intensity value (setting aid).
TIME sets the duration of the ON period, approx.
6 seconds to 5 mins.
Recycling instructions
This device may not be disposed of with the
unsorted household waste. Owners of old
devices are required by law to dispose of
this device professionally. Contact your town
council for further information.
7 6
D
GB
F
NL
I
E
S
N
DK
FIN
RUS
GR
LV
LT
PL
RO
SL
O
SK
CZ
TR
H
Troubleshooting – Practical tips
Problem Cause Remedy
Motion detector switches • Detection range setting • Adjust detection area by
the light on too late • Movement from the front turning the sensor
Motion detector fails to • Motion detector is mounted too low • Mount higher
achieve maximum range • Diff erence in temperature between heat source
and surroundings is not big enough
Troubleshooting – Practical tips
Problem Cause Remedy
Motion detector switches • Constant thermal movement:
light on constantly There are areas within detection range that are
or when not necessary not supposed to be monitored, e.g. footpaths,
roads, trees etc. Unexpected changes in heat
sources caused by storms, rain or fans.
The infl uence of direct / indirect sunlight
Technical data
Field of detection 360° with a beam angle of 100°
Range approx. 3 m
Time adjustment freely adjustable from approx. 6 sec. to 5 min.
Twilight switch freely adjustable from approx. 5 to 1,000 Lux
Mains connection 230 V ~, 50 Hz
Switching capacity 230 V , 5 A (fl oating)
Power consumption approx. 1.4 W
Protection type IP 44 for the sensor, IP 20 for the power section
Protection class II
Subject to technical and design changes without prior notice.