Getinge GE15, Installation Manual, Page: 16 / 48

2.6 Connecting electric power
WARNING!
Only to be carried out by authorized staff.
005786
1
2
3
4
Figure 7. Isolator switch
1. Isolator switch (not
included)
2. Supply cable (not
included)
3. Supply cable
(included)
4. Machine lable
Connect electric power to the machine as follows:
• All variants are equipped with 3 m connecting cable. See the
following table.
• Install the machine in accordance with installation category
CAT II.
• To be pre fused according to the machine lable. See the
following table.
• It is recommended that a residual current device (RCD) also
is installed.
• The supply cable to the isolator switch must be sized
according to local regulations and conditions.
• For easier servicing and maintenance, the supply to the
machine must be fitted with an isolator switch with a 3 mm
isolating gap. The device must be located in an easily
accessible position close to the machine.
• Connect the power supply.
2 INSTALLATION
16 (48) INSTALLATION MANUAL GETINGE WD15 CLARO
<Doc_INS><Doc_6001396702><Rev.I><Lang_en>