001-14154-33-EN rev. 2
5 of 8
2.3 Activate the Pre-Programmed Positions Function (FIDO)
Activating the Pre-Programmed Position function allows the unit to detect stations (positions)
spread along the unit’s course. The unit will be capable of going to the station designated with
the hand control. The user indicates to the unit the position of the desired station (e.g., the third
station equals to three pushes on the PROG button) followed by the direction (LEFT or RIGHT
buttons). The unit then moves by itself to the station designated and stays on hold.
A) Enter the Technical Service Mode and select the third choice (consult section 2).
B) Use the LEFT button to disable or enable the mode. Each push of the button allows you to go from one
section to the next in the table below.
LIFT MODELS
FIDO SETTING
All Models
1 beep*
2 beeps
3 beeps
4 beeps
DISABLE
DISABLE
DISABLE
ENABLE
* Default setting from factory
C) To confirm the activation mode for the FIDO function, press the PROG button.
D) Now you can choose a new selection by pressing on the UP button on the hand control. To return to
normal use, turn off the lift and turn it back on.
2.4 Reset the Service Counter
Resetting the Service Counter allows you to reset the unit’s cycle counter.
This count equals to the number of lift cycles.
A) Enter the Technical Service Mode and select the fourth choice (consult section 2).
B) Use LEFT button to select the reset mode. Each push on the button allows you to move from one
section to the next in table below:
LIFT MODELS
RESET
All Models
1 beep
2 beeps
3 beeps
4 beeps
NO EFFECT NO EFFECT
RESET
NO EFFECT
C) To confirm the selection, press on the PROG button.
D) Now you can choose a new selection by pressing on the UP button on the hand control. To return to
normal use, turn off the lift and turn it back on.
