61
Security Menu
The Security menu contains the security settings, which safeguard your
system against unauthorized use.
NOTE:
You can set the user password only when the supervisor password has
been set.
If both the administrator and user passwords are set, you can enter any of
them for starting up the system and/or entering BIOS Setup. However, the
user password only allows you to view/change the settings of certain items.
A password setting is applied right after it is confirmed. To cancel a password,
leave the password empty by pressing the
Enter
key.
Set Supervisor/User Password
sets the supervisor/user password. You
can set the supervisor/user password to be required for starting up the
system and/or entering BIOS Setup.
Strong Password
enables or disables strong password. When enabled,
the password you set must contain at least one upper-case letter, one
lower-case letter, and one digit.
Password Configuration
sets the minimum password length. Enter the
number in the input field and select
[Yes]
. The number should be
between 4 and 64.
Password on Boot
allows you to enable or disable the entering of
password for booting up your system.
Secure Boot Configuration
You can access this item only after setting
the
Supervisor Password
.
Secure Boot
enables or disables Secure Boot. Secure Boot is a feature
that helps prevent unauthorized firmware, operating systems, or UEFI
drivers from running at boot time.
Delete all Security Boot Keys
deletes all secure boot variables.
Restore Factory Defaults
resets secure boot variables to manufacturing
defaults.
Set SSD 1/ SSD 2 User Password
sets the password for locking the hard
disk drive (i.e. SSD on your computer model). After setting a password,
the hard disk drive can only be unlocked by the password no matter
where it is installed.
