
6
7
EN
EN
ATTENTION:
-Check that the wiring does not obstacle the free movement of the
handlebar in both directions
-Always make sure that the connectors are correctly associated;
when connecting them, a “click” is heard that indicates they are
connected correctly.
NOTE:
To connect both LC-GPA and GET Wifi-Com to GET ECU use the specific
“GL-0084-AA” loom (sold separately). Plug the “MAIN” connector of GET
ECU into the “GP1EVO” connector of the loom. Plug the “MAIN GL-0121-
AA” connector of the LC-GPA into the “GPA” connector of the loom. Plug the
connector of the Wifi-COM into the “WFCOM-PC” connector of the loom.
GL-0084-AA loom
to Wifi-COM
to LC-GPA
GL-0084-AA loom
GP1EVO
connector
GPA connector
WFCOM-PC
connector
to GET ECU
4.
If included, install GET Mode Button on the
handlebar using its clamp. Connect the button
connector to the corresponding LC-GPA wiring.
If GET Mode Button is not included, the
bike you are working on allows to proceed
using the OEM Mode Button. In this case just
connect the “MAIN” female connector of the
LC-GPA as indicated in point 3 and don’t use
the second loom of the LC-GPA. Always check
that the wiring does not obstacle the free
movement of the handlebar in both directions.
MFL
1
10
2
3
4
7
5
6
8
9
LC
D. LC-GPA OPERATION
Once the motorcycle has started, LC-GPA will perform an automatic check of
operation, turning on all LEDs.
After the first automatic check, the LEDs will turn on fixed, showing
the GPA (“Traction Control”) level set (e.g., 3 LEDs = GPA lev. 3).
NOTE:
- On its first installation LC-GPA will show level 5 as factory setting.
- If the GPA level is set to level 0 no LEDs will turn on.
To understand how to change and set the GPA level, see the
section “GPA Setting Mode”.
GPA DISPLAY MODE
MFL
LC
GPA Display Mode