Note:- In Cool and Fan mode, the fan speed can be set to High, Medium and Low. When
Dehumidifier mode is selected and the room temperature is below 25°C the fan speed is
automatically set to Low and cannot be altered from this setting. When the room temperature
is above 26°C the fan speed is adjustable
Cool Mode
In this mode the air is cooled and hot air is exhausted through the vent hose to outside the
room. Fan speed and temperature can be adjusted to suit the comfort level required.
Dehumidifier Mode
Air is dehumidified as it passes through the air conditioner and the damp warm air should be
exhausted by means of the vent hose to outside of the room.
Fan Mode
Air is cooled and circulated throughout the room. Note:- It is not necessary for the vent hose
to exhaust outside the room.
Fan Speed
The fan speed can be set to high, medium or low. Note:- In dehumidifier mode, depending
on the room temperature, only low fan speed is available. (See Note in Mode Control above).
Timer
Press the Timer button to set the timer. The green LED next to the ON/OFF legend will flash
on and off for 15 seconds.
While the green LED is flashing, press the timer/temp adjust buttons (
▲▼
) to select the time
(in hours, between 00 and 12)) for either of the timer modes “a” or “b” as detailed below. The
time selected is shown on the display panel. After the 15 seconds the display will revert to
showing the room temperature.
If no time has been selected the timer will be off and the green LED will not be illuminated.
Timer mode a) Auto Turn Off
:- With the machine on and running press Timer and then the
Timer/Temp Adjust buttons (
▲▼
) to select the number of hours you would like the unit to run
until it automatically shuts off. The green timer LED will remain lit.
Timer mode b) Auto Turn On
:- Switch the machine on using the Power button so that the
machine is running and the desired mode is selected. Press the Power button again to put
the machine into stand-by mode. With the machine in stand-by mode, press the Timer button
and then press the Timer/Temp Adjust buttons (
▲▼
) to select the number of hours until it is
required for the machine to start up automatically. The green timer LED will continue to flash
and the display will show the time set.
Timer/Temperature Adjust buttons
In Cooling or Dehumidifying mode, the temperature can be manually set by pressing the
Timer/Temp Adjust buttons (
▲▼
) between the limits of 16° to 32°C as shown in the display
panel. This cannot be done in Fan mode. The default setting is room temperature. After 15
seconds the display will revert back to room temperature.
IMPORTANT
When the appliance is in Cool or Dehumidifier mode, most moisture will be vented out
through the vent pipe. However, in certain circumstances some condensation may collect in
the water tank at the bottom of the chassis. When this tank is full, the “water full” indicator
(
) will illuminate (red) and the appliance will stop running. The appliance should then be
unplugged from the supply socket and the rubber plug in drain port at the lower rear
of the
machine should be pulled out to drain the water into a suitable container. Alternatively, move
the appliance to a suitable place to drain the water.
Note: When the water full light (
) is on, the water should be
drained out. If the water is not drained out, the appliance will
not operate.
