Operation
CONTROL PANEL
CONTROLS
Cooling Control
This control sets the desired temperature and the compressor will turn off when this
temperature is reached but the fan will continue running. When the room temperature rises
the compressor will come back on and resume the cooling operation. If maximum cooling is
required, this control should be turned to the CONT position.
Fan Speed Control
This control sets the fan speed in FAN ONLY or COOLING operation.
Timer Control
This control allows you to set the time that you wish the machine to run, in one hour intervals
(up to 8 hours). The machine will stop when the selected time has expired.
If it is required that the machine runs continuously the control should be set to the CONT
position.
Water Full Alarm
The GPACU12H has a unique system to dispel condensation automatically but in certain
circumstances some water may collect in the water tank within the machine. When this tank
becomes full, the water full indicator will illuminate red and the machine will stop working.
When this occurs it is necessary to drain the water from the machine by removing the rubber
bung from the hose at the rear of the unit. After draining the water, the bung should be
replaced in the hose and the unit switched on. If after draining the tank, the warning light
remains on, this could indicate that there may be a fault with the machine. If this is the case,
do not attempt to operate the machine and call the service number.
Note: When the Alarm light is on, the water should be drained
out. If the water is not drained out, the appliance will not
operate.
