Web management system
Web management system
USER MANUAL | EG-6620 Digital Conference System
15
CERTAIN UNIT ADDRESS
To allow user to allocate a specific ID to a microphone unit.
For example: A system consisted 30 mics, when an extra microphone to be included into
the system, then user can define this mic’s ID as 31 separately.
Note: Should only 1 microphone unit connected to the controller on this opera on.
Other microphone units should be disconnected during this opera on.
Mee ng setup
QUEUE MODE
Provide FIFO & FILO op ons.
SOUND CONTROL ON/OFF
To allow delegate to open the
microphone unit with voice.
PRIORITY SETUP
Auto recover - Delegate units will be
muted if priority key keeps being pressed,
the delegate unit will unmuted when
priority key released.
Manual recover - Delegate units will be
switched off when priority key is pressed,
delegate unit can open by pressing the
ON key again.
SPEAKING QTY
Applied to delegate unit only, to define the qty
of delegate unit can open.
MEETING MODE
Discussion - camera tracks to the last switched
on microphone unit.
Auto - camera tracks to microphone unit which
received voice signal.
Chairman - Only chairman unit can be
switched on.
All On - All microphone units can be switched
on, no limit on OPEN MIC qty.
USER MANUAL | EG-6620 Digital Conference System
14
Login page
Web management system
is the portal to allow operator to configure the system on
computer .
The system is embedded in the controller, no so ware installa on required. User should just
enter the IP address in the browser to access the system.
IP address of the controller should be set in the same network segment as the computer
device in advance, user can check and configure the IP address from SYSTEM SETUP menu
on the controller.
Setup address
SETUP ALL UNIT
To configure the ID of all microphone units connected to the system. User can input the
ini al ID, and ID will be set in ascending order to each microphone unit ll all units assigned,
then reboot the controller a er the opera on. Click SETUP to start the process , and
COMPLETE to end the process.
