Gerni Classic 100.3, User Manual

Page: 12 / 21

12
Original Instructions

ditional fi ltering to secure that impurities are not sucked in. Hose length should be max. 3 meter
and of minimum ½".
To meet these requirements, Gerni recommends that you use the original Gerni suction hose
kit.
The Machine is designed for suction up to 50 cm above the water surface.
• Position the machine at max. 0.5 meter above water surface. Detach the high pressure hose
from the outlet.
• Ensure that the inlet fi lter is in position and attach the suction hose kit, secure tight connec-
tion to the inlet.
• Turn on the machine, pressing the start/stop switch (1) into position "I".
• Wait until a steady jet exits the outlet.
• Switch off the machine and attach high pressure hose (4), spray handle, lance and nozzle.
• Start the machine again and activate the spray handle.
4.4 Starting the high pressure washer
IMPORTANT!
Connecting to mains power supply
The voltage and frequency of the machine (see model tag (14)) must match the voltage and
frequency of the power supply.
B9
Insert the power plug into power supply socket.
B10
Turn on the water.
B11
Release the trigger lock (7a). Remember to unplug, turn off the high pressure washer and
lock the trigger, when leaving the high pressure washer unattended
B12
Activate the trigger of the spray handle and let the water run until all air has escaped from
the water hose.
B13
Turn on the machine, pressing the start/stop switch into position “I”.
B14
Activate the trigger of the spray handle. When releasing the trigger of the spray handle,
the machine automatically stops. The machine will start again when you reactivate the
trigger of the spray handle.
5 After using the pressure washer
See the pictorial quick reference guide – storing the high pressure washer.
The high pressure washer should be stored in a frost free room! Should the machine by a mis-
take be frozen, it will be necessary to check it for damages.
5.1 Stopping the high pressure washer
C1
Shut off the water supply and activate the trigger of the spray handle and let the machine
run until no more water runs out of the nozzle. This will wash out water hose, high pres-
sure hose, spray lance and nozzles.
C2
Stop the machine, pressing the start/stop switch into position “0”.
C3
Unplug the machine from the power supply socket and wind up the electrical cable (5)
and place it on the holder (16).
C4
Rinse the spray lance, nozzles and the foam sprayer after use.
C5
Place spray handle, lance, nozzles, foam sprayer and other accessories in the holders on
the high pressure washer.



I O
C