Germfree BZ Series, User Manual

Page: 14 / 53

Horizontal Laminar Flow Workstation
User Manual
14
Installation Instructions
Your hood is transported fully assembled and operational . It can be set up on a desk or table, plugged into an
outlet and will be ready to be certified . However, if you are also receiving a stand for the hood, some assembly
may be required . Set height stands for our 3, 4 and 6 foot models will need to be assembled . Any 8 foot stand is
shipped fully assembled, with the components welded together to support the weight of the hood . If the stand
has an electric or manual lift system, it will arrive fully assembled for all stand lengths . The stand and the hood
may be shipped separately depending on the length .
The instructions below relate to the assembly of the stand and the placement of the hood on top .
Stand Assembly
There are 5 components to the broken down stand: the top of the stand, two pre-assembled side pieces and the
two rear supporting braces . The pieces are connected by tightening set screws in fittings . The assembly starts
with inverting the top of the stand on the ground .
Next, the two side pieces that are already assembled (Blue) should be connected with the rear supporting
braces (Red) . The supporting braces are inserted into the fittings on the side pieces and the set screws can be
tightened . There will be 4 set screws to tighten during this step .
Fig . 1 Inverted Top of the Stand
Fig . 2 Assembled Side Pieces with attached rear supporting
braces