8
Getting Started
ASSEMBLING THE STAND.
NOTE - use the illustration of Product Overview while
following instructions.
1. Make a cross with the cross bases (20) by fitting them together at the
center. The four end caps (21) will be pre-assembled to the end of the
cross bases.
2. Loosen the four base screws (19) from the cross base and remove.
Align the four holes on the bottom of the base tube (17) with the four
holes in the cross base.
3. Insert the four base screws (19) into the aligned holes and tighten
them completely.
4. Turn the height adjustment ring (16) and remove it.
5. Slide the base cover (18) down so that it covers the screw tops in
the cross base.
6. Replace the height adjustment ring (16) but do not tighten.
7. Extend the extension pole (15) and secure it by tightening the height
adjustment ring (16).
NOTE -
If the extension pole is not readily visible, look inside the base
tube (where it is located) and pull it to extend completely.
8. Attach the control panel (13) with the motor housing (11) assembly to
the top of the extension pole (15).
9. Tighten the adjustment screw at the rear of the control panel to fix the
control panel and motor assembly onto the extension pole (15).
