German pool WIN-24SB, User Manual

Page: 6 / 17

P.11 P.10
Operation Instructions Operation Instructions
WARNING!
• DO NOT flush the product body with water.
• DO NOT wipe the body using gasoline or other organic solvents.
• If the power cord is damaged, it must be replaced by German Pool Customer Service & Repair
Centre to avoid any danger.
• All power sockets must be reliably earthed.
Before Initial Use
1. Clean the product: Before operation, clean the interior of the product, and check whether the vent
pipe is clogged.
2. After cleaning, DO NOT plug in the power source immediately. Wait at least 30 minutes before
plugging in the power, this is to ensure the normal operation of the product.
3. Close the product door, and plug in the BS plug.
4. After the power supply is switched on, the product will start to work. If the product fails to turn on,
check whether the power socket and the electric circuit are working normally. If, half an hour lat-
er, you open the product door and it is cold inside, this indicates the product is working normally.
Note:
• Generally, DO NOT turn off the product, to avoid influencing its normal service life. After unplug -
ging from the power source, wait for at least 5 minutes before re-plugging, to ensure normal
operation of the product.
• DO NOT switch off the power supply of the product unless necessary, because power interruption
may cause temperature to rise inside the product, thus shortening the storage term of wines and
degrading their drinking quality.
• A certain space should be maintained between wine bottles, in order to facilitate the circulation of
cool air.
• To ensure the product will operate at the most efficient capacity, it is advisable not to change the
setting after the initial set-up of the product.
Control Panel
KEY FUNCTION
On/Off
Lamp
Increase
Decrease
Degree Switchover
Child Lock
• Long-press for 3 seconds, product enters standby
status.
• In standby status, pressing this key will return the
product to operation status.
Cycles between Light On and Light Off modes
• Light On Mode:
Lamp will remain lit (at 50% brightness) when door is
closed, and 100% brightness when door is open.
• Light Off Mode:
Lamp will light up (at 100% brightness) when door is open,
and go dark when door is closed.
Each press increases cellar temperature by 1°C. When
pressed, LCD display will flash to indicate current
temperature. After user has adjusted to desired
temperature, 5 seconds later LCD will light up constant and
the new setting will be memorized.
Each press decreases cellar temperature by 1°C.
When pressed, LCD display will flash to indicate current
temperature. After user has adjusted to desired
temperature, 5 seconds later LCD will light up constant and
the new setting will be memorized.
Press these 2 keys simultaneously to switch between
Celsius and Fahrenheit degree for display
(Switchover is not possible during setting of cellar
temperature.)
Long-press these 2 keys simultaneously for 3 seconds to
activate or deactivate Child Lock.
(When the cellar is left idle for several seconds, Child Lock
will be automatically activated).