Installation
INSTALLING THE WINE COOLER
Your Electrolux wine cooler has been designed for either free-standing or built-in
installation(refer to the
Built-in Installation
section of this manual for instructions).
In either case, the front grille must NOT be obstructed.
SITE PREPERATION
1
Position the unit on a flat, level surface, capable of supporting the entire
weight of the unit. Remember the unit will be significantly heavier once it is
fully loaded.
2
This unit requires a grounded and polarized 115 VAC, 60Hz, 15A circuit
(normal household current).
3
Avoid connecting the unit to a Ground Fault Interruptor (GFI). GFIs are prone
to nuisance tripping which will cause the unit to shut down. GFIs are generally
not used on circuits which power equipment that must run unattended for
long periods of time.
4
The unit must be installed according to your local codes and ordinances.
!
D
D
D
D
DANGER
ANGER
ANGER
ANGER
ANGER
ELECTROCUTION HAZARD!
Electrical Grounding Required. This appliance is equipped with a three prong
(grounding) polarized plug for your protection against possible shock hazards.
•
NEVER remove the round grounding prong from the plug.
•
NEVER use a two-prong grounding adapter.
•
NEVER use an extension cord to connect power to the unit.
Where a two-prong wall receptacle is encountered or a longer power cord is required,
contact a qualified electrician to have it replaced in accordance with applicable
electrical codes.
