German pool REF-195, User Manual, Page: 9 / 19

P.17 P.16
Lamp specification is listed in rating label.
Follow below process to replace the lamp:
1. Set the temperature regulation knob at number “0” to switch
off the appliance.
2. Unplug the appliance to make sure the appliance is discon-
nected from main power supply.
3. Remove the lamp cover out by a flat screw driver.
4. Unscrew the lamp by fingers.
5. Fit new lamp according to the opposite direction, then replace
the lamp cover.
6. Plug in the appliance and regulate the knob to right position.
Defrosting
The evaporator, however, will become progressively covered with frost. This should be removed. Never
use sharp metal tools to scrape off frost from the evaporator as you could damage it. However, when
the ice becomes very thick on the evaporator, complete defrosting should be carried out as follows:
-pull out the plug from the socket;
-remove all stored food, wrap it in several layers of newspaper and put it in a cool place;
-keep the door open, and placing a basin underneath of the appliance to collect the defrost water;
-when defrosting is completed, dry the interior thoroughly
-plug in the power to run the appliance again.
Cleaning and Maintenance
Replace the lamp
Caution! Before replacing the lamp, disconnect the appliance from mains power supply.
Troubleshooting
Caution! Make sure the power supply is disconnected. Only a qualified electrician can do the trouble -
shooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
PROBLEM CAUSE SOLUTION
Appliance cools too much
Unusual noises
Appliance is not level.
The appliance is touching the wall
or other objects.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
The food is too warm.
Temperature regulation knob is set
at number “0”.
Appliance does not work
Mains plug is not plugged in or is
loose
Fuse has blown or is defective
Socket is defective
Set the knob at other number to
switch on the appliance.
Insert mains plug.
Check fuse, replace if necessary
Mains malfunctions are to be cor-
rected by an electrician.
Temperature is not properly adjusted.
Door was open for an extended
period.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
The appliance is near a heat source.
Please refer to the Initial Tempera-
ture Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation to
a colder setting temporarily.
Temperature is set too cold.
Turn the temperature regulation
knob to a warmer setting tempo-
rarily.
If the malfunction still occurs, turn off the appliance and call Customer Service & Repair Centre.
Please refer to the installation
location section.