German pool PRO-6S, Operating Instructions Manual

Page: 7 / 20

Operating Instructions
P.7
Important
Do not run the appliance without loading. It is strictly forbidden to operate this appliance without the presence of
any liquids, solids or semi-solids inside the blending jar.
Under no circumstances should the blending jar be immersed in any liquids. Do not spray or splash any liquids at
the blending jar base. Do not directly rinse the blending jar base under the tap. The blending jar is not suitable for
the dishwasher. If the blending jar base is sprayed or splashed wet, dry immediately.
Under no circumstances should the blending time exceed 1 minute when dry-grinding substances. It is advised to
let the appliance rest for 5 minutes before resuming dry-grinding.
Time Setting
- When the preset time is less than 1 minute, pressing time setting buttons will increase or decrease 5 seconds.
- When the preset time exceeds 1 minute, pressing time setting buttons will increase or decrease 10 seconds.
- Keep pressing the time setting buttons will fast forward the time setting.
- The longest time setting is 30:00 (minutes). If it is set to 00:00, the blender has no action.
- Continuous operation:
To continuously run the blender, set your favourite mode and then adjust the time setting to 88:88 by pressing
once after 30:00. In this condition, you can control the blender to run continuously or stop by pressing
the On/Off button.
B. Button Functions
A. Operating Procedures
1. Power On
- Check and make sure the electrical rating shown on the rating label corresponds with the power supply in your
house. Insert the plug into the socket and place blender jar onto the unit properly. Note: If blender jar is not inserted
to jar base properly, do not press it with force. You may slightly rotate the drive coupling and insert the jar again.
When inserted properly, the unit will give a beep sound.
- LCD display will show all icons and digits, and the buttons will light up for 1 second. Then, the unit will enter standby
status.
- Standby status: It only shows the time as “00:00” and the speed as “3”. The LCD display will light up in blue. On/
Off Switch will light up in red and the other button backlights will be off.
- Press any button and all button backlights will be on.
2. Select the Program
- Select Time & Speed Settings, an Operating Mode, or one of the Preset Programs (see “Button Functions” below).
Then, press On/Off Switch. Operation will start, and On/Off Switch will light up in white.
- After any program finishes, the blender resumes to stand-by status.
- To stop the operation, press On/Off Switch. All settings will be cleared.
Time+
Time- Time+