German pool GRM-450, Operating Instructions Manual

Page: 13 / 16

1.Make sure the rated voltage is compatible with
the Healthy Rice Bran Miller’s voltage range.
2.Connect the unit to a power source. The unit will
beep twice when it is properly connected to a
power source. This indicates that the unit is ready
for use.
3.Open the front cover of the unit and ensure the
metal plate is pulled forward to allow rice to fall
onto the milling cutter.
4.Remove the lid and add the rice to be processed
(brown or red) to the top of the unit. Press POWER
to begin the rice milling process. The default
processing time is set at 7 minutes. Processed
rice will fall out of the opening in the front of the
unit.
5.Press “-“ or “+” to adjust operating time in 1 minute increments. The time can
be set or changed as required from 1 to 9 minutes.
6.Change the purifying degree as required by rotating the knob on the front of the unit.
7.The digital display will show the minutes remaining in the processing cycle. When
this number reaches 0, the unit will turn off.
8.If the chaff container is getting too full, press POWER to abort the milling
process. Remove the chaff container and empty it of bran before inserting it back
into the unit.
If there is any problem when you use the device, please follow the instructions below
to check. If the problem persists or the device does not work normally, please turn
off the power supply and contact service center or a licensed technician. Do not
attempt to disassemble and repair the device yourself.
Cleaning the Unit
P.13
Care & Maintenance
Troubleshooting
Problem Cause Method
Self-test sound does not
play
The plug is not properly
inserted
Check the power socket
The unit lacks power
Verify that the outlet is
powered
Unit makes continuous
sounds
The front cover is not properly
closed
Make sure the front cover is
properly installed
Unstable power supply
Ensure the supply voltage is
stable
Foreign materials blocking the
milling cutter
Remove the milling blade,
clean, and reinsert
None of the above Send to the dealer for servicing
Clean the sieve with the provided
brush and install the sieve and
cutter back inside the housing
of the unit. Reassemble the unit,
reversing the above two steps.
To clean the unit, open the front
cover. Push the metal plate
above the cutter forward (to
prevent rice from falling)
as shown in the picture below.
Gently depress the two clips
shown in the picture below and
pull out the sieve and cutter.