P.6
組裝方法
1. 將螺母和網束從電機軸上取下。
2. 將後網對準電機前殼的定位支柱套入。再用網束
把後網固定在機身上。
3. 對準插槽將風扇葉套到電機軸上，再逆時針鎖緊
螺母，固定好風葉。手動檢查風葉 轉動是否順暢。
4. 鬆開前網底部的網環螺絲，放鬆網環；從後網
頂部開始套入前網，按壓前網周邊使前後網完
全吻合，鎖緊網環螺絲，收緊網環。
5. 底盤組裝
將電源線卡到底盤的缺口處，將立柱的凸點與底
盤內的缺口處對齊，插入後順時針擰緊。
操作說明
Operating Instructions
Assembly Desk Fan
1. Remove the spinner lock nut and guard lock nut from
the motor shaft spindle.
2. Fit the rear guard, by the positioning on the location
pins. Secure the guard to the motor body with the
guard lock nut.
3. Push the fan blade onto the motor shaft by matching
the slots on the base of the blade with the shaft
pin. Secure the blade with the spinner lock nut.
The spinner lock nut must be tightened by turning
it in a counter-clockwise direction. Check that the
fan blade rotates freely by turning with your hand.
4. Open the securing clip at the bottom of the front
guard and loosen the clip screw. Position the top
clip on the uppermost part of the rear guard.
Push the top clip down and press rim of the front
guard onto the rear guard. Close the bottom clip
and tighten the screw.
5. Base assembles
Put power cord into the base hole and set the
bulge of stand tube alignment with space of base
hole, and turn the stand tube by clockwise direction.
前網
Front Guard
網環螺絲
Gurad
Securing
螺母
Spinner
Lock Nut
插銷
Shaft Pin
凸點
Bulge
缺口
Space
底盤
Base Plate
風葉
Fan
Blade
網束
Guard
Lock Nut
後網
Rear
Guard
電機軸
Motor
Shaft
拉杆
Oscillation Control Knob
電機殼
Motor Cover
1.將電源線卡到底盤在缺口處，將立柱在凸點與底
盤內的缺口處對齊.
Put power cord into the base hole and set the bulge
of stand tube alignmengt with space of hole.
2.逆時針方向旋轉.
Turning in a counter-clockwise direction.
