German pool EFB-326H, User Manual

Page: 6 / 15

P.11 P.10
Operating Instructions
Remote Control
The Remote Control should be pointed at the Remote Control Signal Receiver on the display to
maximize the remote control signal. Effective distance: 5M.
After switching the product to a standby mode, use the main switch in
the product to power off, since using the Remote Control to turn it off
would not cut off electricity completely. When the product is not in use
for a long time, please unplug the power cord.
On/Off
The device can be switched on and off by pressing the "On / Off" Button
Sleep Mode
Press “Sleep Mode” Button on the Remote Control.
The display shows “LL” and the fan speed becomes lowest.
Press again to exit the “Sleep Mode”.
(You can also exit the current mode by pressing the Wind St button.)
High Cool
Press “High Cool” Button on the Remote Control.
The display shows “HH” and the fan speed become highest.
Press again to exit the Turbo Mode.
(You can also exit the current mode by pressing the Wind St button.)
Oscillating
Press the “Oscillating” Button to turn on the Oscillation Function.
This fan can swing left and right at 80o. Press this button again to stop oscillating.
Sound
Press “Sound” Button to turn on/off the sound of fan. The sounds refer to the tone of
turning on and off the fan using the Remote Control.
Cool Mode
During Cool Mode, the LED display is on with blue light.
Press this button to activate the Cool Mode.
Note: The default Start Mode is the Cool Mode.
Increase /
Decrease
Air Volume
Press the “+” Button on the left side of the Remote Control
to increase the volume of air; press the “- ” button on the left side of the Remote
Control to decrease the volume of air.
Cool Mode can be used for 9-level settings, Warm Mode can be set for 4 levels.
Warm Mode
Press this “Warm Mode” Button to activate the Warm Mode.
The display number in Warm Mode is orange.
Note: During Warm Mode, both High Cool and Sleep Mode are not available.
Raise /
Reduce
Temperature
In Warm Mode, press the “+ - ” Button on the right side
of the Remote Control to set the Temperature (1-30°C).
Note: this button does not work during Cool Mode.
Timer
Press the “Timer” Button on the Remote Control to set 1 to 8 hours of timing.
Operating Instructions
开关
机
Signal Receiver
Caution:
Remote Control error sometimes occurs due to the overlap of the channel frequencies. For example:
1. This product may react to the remote control of another appliances nearby; or
2. When using the remote control of this product, other electrical appliances may react.
In order to avoid misuse, please operate this Remote Control away from any other appliances.