P.8
操作說明
OPERATING INSTRUCTIONS
使用前預備
首次使用熱水壺前，加水至最高水位並煮沸一
次，然後將熱水倒出，以徹底清洗熱水壺。
操作方法
1. 確定水量調節掣在升起位置。壺蓋開關向後
按以打開壺蓋。(圖1)
2. 為「儲水水箱」注水至“MAX”(最高水位) 的
位置，然後壓下壺蓋，以確保壺蓋開關已鎖
上。(圖2)
3. 將熱水壺放在電源底座上，接駁並開啟電源。
(圖3)
4. 調校需要煮沸的份量 (選用省電或全煲模式)：
A.省電模式 —
僅煮沸所需份量
(200毫升至1公升 / 1至5杯水)
留意前方的「加熱水箱」，同時向下按壓水
量調節掣數秒，將需要煮沸的份量從儲水
水箱傳送至加熱水箱，直至加熱水箱中
的水位上升至你所需要的份量(圖4) — 水
位必須介乎加熱水箱上“min fill”(圖5)
及“max boil”(圖6) 兩個標記之間。
注意：調校需要煮沸的份量後，保持水量
調節掣在升起位置 (圖7)，切勿往下扭緊。
Preparation
Before using the kettle for the first time, boil a full
volume of water and discard it to ensure that the
interior of the kettle is completely clean.
Operation
1. Check that Valve Button is in raised position. Pull the Lid
Latch backward, and then open the hinged lid. (Fig.1)
. Fill Reservoir with water to the “MAX” level.
Close the lid using a downward pressure to
ensure that the Lid Latch engages fully. (Fig.)
. Place the kettle on its Power Base. Plug in the Power
Cord to a power socket and switch on the power. (Fig.)
4. Adjust the amount for boiling (select either Eco
Mode or Full Tank Mode):
A.
Eco Mode
–
Boil only the amount of water you need
(00 ml – 1 L / 1 – 5 cups)
Press Valve Button downwards and release
when water level in Boiling Chamber rises to your
desired amount (Fig.4). While doing so, watch the
exterior of Boiling Chamber to make sure water
level reaches its “min fill” mark (Fig.5), and do not
fill above the “max boil” mark (Fig.6).
Notice: After adjusting, keep Valve Button at
raised position (Fig.7). Do not keep it locked at
downward position.
