P.11
P.10
Operating Instructions
Dry Mode
This mode is for drying laundry. When the product is turned on, press until DRY Indicator lights
up, Display Panel shows ambient humidity, humidity level cannot be adjusted. After product has
continuously run in Dry Mode for 24 hours, it will automatically return to Dehumidify Mode at default
humidity of 60%RH.
Note:
•
Dry Mode facilitates the drying of laundry by lowering ambient humidity level, not direct drying
laundry with dry heat.
•
At all times, DO NOT cover the product’s air outlet, and DO NOT hang wet laundry on top of the
product to avoid water dripping into and damaging the product.
•
When drying laundry, please close all windows and doors to facilitate the drying process.
Dehumid Anion Mode
Press until DEHUMIDIFY and ANION Indicators both light up. The product runs in the principle of
Dehumidifying mode but together with Anion function.
Timer Function
Countdown To Switch On:
When the product is in standby status, press and set time from 0.5-24
hours by pressing or . After 5 seconds, Timer will start to coundown; once the set time arrives, the
product will turn on automatically. To cancel Timer, press again.
Countdown To Switch Off:
While the product is running, press . and set time from 0.5-24 hours
by pressing or . After 5 seconds, Timer will start to countdown; once the set time arrives, the
product will turn off automatically. To cancel Timer, press again.
Automatic Defrost
Should frost build up on the evaporator coils, the compressor will stop running and the fan will
continue to run until the frost disappears. When the coils are completely defrosted, the compressor will
automatically restart and dehumidifying will resume.
Operating Instructions
Take out the water tank, empty the water and reinsert properly into the product.
Note:
Do not place the water tank on the floor when it is full as it is uneven on the bottom and water may spill.
Water Tank Full Alert
When the water tank is full, the compressor and fan will automatically turn off, TANK FULL indicator
will flash. 3 minutes later, the buzzer will beep; 6 minutes later, buzzer will beep again to remind user
to empty the water tank. 5 seconds after the water tank has been emptied and properly reinstalled,
TANK FULL indicator will stop flashing and product will restart.