German pool CRH9, Operating Instructions Manual

Page: 9 / 40

CRH 9
6. Installation
9
Installing the wall bracket (surface-mounted):
1. Thoroughly rinse the water supply pipes before installation to remove soil-
ing from the pipes.
2. Screw the 1/2“ screw in nipple and the 1/2“ seal into the 1/2“ union nuts of
the hot-water connector.
3. The 1/2“ cap of the side outlets of the coldwater connectors must be
removed and screwed onto the open end of the screw-in nipple.
4. Mount the fine filter into the cold water connection piece (8 d).
5. The hot-water and cold-water connectors must then be screwed into the
3/8“ union nut of the appliance and delivery pipe, together with the 3/8“
seals.
6. Mark the drill holes and drill them using a 6 mm drill. Mount the unit to the
wall and connect the water supply of the unit.
7. The holes in the housing of the unit required for the pipes must then be
broken out of the housing with the aid of a blunt implement.
8. Open the water supply line to the unit and slowly open the shut-off valve
in the cold water connection piece (drawing 8a on page 6).
Check all connections for leaks.
9. Next, open and close the hot water tapping valve several times until no
more air emerges from the line and all air has been eliminated from the
instantaneous water heater.
8d