GLP
German Light Products GmbH
(Instruction version 1.01) / from software version 1.02
9
the fixtures base can become damaged, and a secure installation cannot
be assured.
2.2 Securing the device
Regardless of the mounting method of the
I
I
m
m
p
p
r
r
e
e
s
s
s
s
i
i
o
o
n
n
W
W
a
a
s
s
h
h
o
o
n
n
e
e you'll have to
use a secondary safety wire. This safety wire can be attached to the fixture by
threading it through one of the two holes provided on the base of the fixture.
Ensure that the safety wire is securely fastened through the fixture and the
fixtures mounting support. Install a safety wire that can hold at least 10 times
the weight of the fixture.
2.3 Connections
2.3.1 Power Supply
Autosensing ~100-240 Volt AC, 50-60 Hz, earth contact type plug via
Powercon
Connected load 450 VA (W)
<=>
T8A (micro-fuse 6.3x32mm)
Disconnect from the mains supply before changing the fuse and
use only the above described micro-fuse type.
2.3.2 DMX
USITT DMX-512 Standard input/output via 3 pin and 5 pin connectors.
3 pole: Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+]
5 pole: Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+] / Pin 4/5 n.c.
Ethernet (Artnet II compatible, ACN ready)
Neutrik RJ-45 plug (for Neutrik EtherCon connector with body)
