GLP
German Light Products GmbH
(Instruction version 1.6) / from software version 1.19
9
2.3 Connections
2.3.1 Power Supply
Autosensing ~100-240 Volt AC, 50-60 Hz, earth contact type plug via
Powercon
Connected load 450 VA (W)
<=>
T8A (micro-fuse 6.3x32mm)
Disconnect from the mains supply before changing the fuse and
use only the above described micro-fuse type.
2.3.2 DMX
USITT DMX-512 Standard input/output via 3 pin and 5 pin connectors.
3 pole: Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+]
5 pole: Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+] / Pin 4/5 n.c.
Ethernet (Artnet II compatible, ACN ready)
Neutrik RJ-45 plug (for Neutrik EtherCon connector with body)
3 The Menu Field
You’ll find the control board on the side of the arm. It allows you to make all necessary
adjustments of the
I
I
M
M
P
P
R
R
E
E
S
S
S
S
I
I
O
O
N
N
S
S
p
p
o
o
t
t
O
O
n
n
e
e
.
. With the Menu-key you get into the main menu.
Afterwards you can navigate through the menu with the Touchwheel. Push the Enter-key to
get to the next menu level or to confirm your settings. Select ON/ OFF function settings with
the Touchwheel. Confirm and save with the Enter-key. Push the Back-key to cancel the
entry and go back to the main menu.
Back - Enter
Layer 1
Layer 2
Layer 3
Layer 4
Notes
DMX Start
Address
Set the DMX start address
Personality Pan/Tilt
Pan/Tilt settings
Pan invert
Selects Inverse Pan, on or off
Tilt invert
Selects Inverse Tilt, on or off
Feedback
Automatic position feedback selection for
pan/tilt movement
DMX
Address
Set the DMX start address
